![]() ![]() Ordered either a framed or overlay model, you will be installing panels to give the unit the custom Sub-Zero look. IMPORTANT NOTE: Let your customer know that the ice maker will not fill with water immediately, and that the first few batches of ice produced should be discarded. Make sure the filter is positioned and accessible for replacement when necessary. IMPORTANT NOTE: If for any reason the unit has been laid on its back or side Then locate the proper door(s) closed on the unit until it is properly anchored. All Built-In models are equipped with rollers, Locate and mark two wall studs against the wall where the Built-in unit will be installed. In order to prevent damage to the grille and to access the power cord, the top grille assembly should be removed prior to moving the unit. Keep door(s) and drawer taped closed while moving unit. The ice maker operates on water pressure of 20 psi (1.4 bar) to For location of the water supply, refer to the Installation Specifications illustration for your specific model on pages 5-7.Ī line filter is required when water conditions have a high sediment content. ![]() Door swing clearances are based on stainless steel door and handle dimensions.ĭimensions are for finished rough openings.ĭoor swing clearances are based on stainless steel door and handle dimensions.ĮXTEND WATER LINE APPROX 36" (914) FROM BACK WALLĪre based on stainless steel door and handle dimensions.ĭimensions in parentheses are in millimeters unless otherwise specified.įor easy connection to the unit. ![]() Dimensions are for finished rough openings. Models 601R and 601RG will not require the water line connection. Refer to the Overall Dimensions and Installation Make sure that the finished rough opening where the Built-In unit is to be installed is properly prepared. If the unit you receive does not match your requirements, contact your Sub-Zero dealer. By reading these instructions carefully, you will make the installation process easier, problem-free and, most importantly, safe.Īny questions or problems about the installation should be directed to your Sub-Zero dealer or the Sub-Zero Customer Service Department at Check our website,, for the most up-to-date specifications.ĭuring the installation. Specifications are subject to change without notice. Sub-Zero 650 | Built-In Installation Guide. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |